From time to time, roll forming equipment manufacturers make slight “tweaks” and dimensional changes in their roll tooling. Recently we became aware that the S-5 N may not seat properly on limited profiles. If the profile is wider than .56 inches at the base, the current S-5-N clamp may not fit over the seam. For a full explanation Click Here.
S-5-N Mini Clamp
The S-5-N Mini is a bit shorter than the S-5-N and has one setscrew rather than two. The Mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*
*S-5! Mini clamps are not compatible with, and should not be used with, S-5! SnoRail™/SnoFence™ or ColorGard® snow retention systems.
Installation is Easy
An angled wall with a nose permits the S-5-N to engage the triangle type profiles during the installation process—there is no longer a need to hold the clamp in place while setscrews are tensioned. The combination of these two features allows the clamp to sit straighter on the seam.
Please note: The above image illustrates the S-5-N. The steps remain the same for the S-5-N Mini; however, there will only be one setscrew on the clamp.
Load Test Results
Contact your distributor for pricing and ordering.
Product packages in boxes of 50 and cases of 250.
Broken box quantities may incur additional charges.
Setscrews, flanged bolts and a screwgun bit tip are included in each box.