| Prev Next |
Step 2- Preparing the Clamps
VersaClip™ assembly with bolt hole on the upslope end of the clamp.
|
If the ColorGard® assembly utilizes the VersaClip™ for attachment of the ColorGard® crossmember, the bolt hole in the clamp should be at the upslope end of the clamp.
S-5!™ clamp without the VersaClip™ with the bolt hole shown on the downslope end of the clamp.
|
If the assembly does not use VersaClip™, the hole should be at the downslope end of the clamp. Determine which side of the clamp to load the setscrews into, and assemble all setscrews to all clamps, being careful that the bolt hole will be in the correct (upslope or downslope) orientation, with the setscrews on the correct side of the seam.
S-5™ clamps are available to fit almost any seam. Refer to the Clamp section of this Web site to view installation instructions.
| Prev Next |